The pins where we are going to make connections are in red. No, I am not mistaken, yellow wire is 12v, but for that we have voltage regulator LCV: The second pad will have a all functionality all the buttons work and even force-feedback. Remember that you must weld the 5 diodes in the correct direction. To feed we pad with 5v by means of an external power supply a second power block, if we were using the Force Feedback.
|Date Added:||19 August 2018|
|File Size:||39.56 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Solder the corresponding pin to each of the wires from the extension.
Win9X Direct Pad Pro 5 installation
Remember that you must weld the 5 diodes in the correct direction. If what you need is 9v or too lazy to get and external power supply, you can get that from inside too.
The pins where we are going to make connections are in red. Before starting, we are going to make sure that you have a free power connector. They are similar to this:.
Keep this paper in a safe place that you will ditectpad it later. Get the newest DirectPad drivers of here and unzip it to a temp directory anywhere, ei. No, I am not mistaken, yellow wire is 12v, but for that we have voltage regulator LCV: If your controller doesn’t power up many racing controllers need more power than the parallel port can supply, for example you may want to try adding an external 5V diectpad supply:.
The connection goes to the parallel port, which means that if you are going to use the printer you change connectors Report by Emulatronia http: Nothing of anything in the driver works. And that is it.
Connect the PSX pad to PC
Well, we now have written on the diredtpad the relation of the holes from the 1 to the 9 and to what cable color in the other end corresponds to each one of them. And we are now in the last of the mechanical part. Iomega, Syquest, SparQ, Jaz, Zip, and other names are trademarks or property of their respective owners. Pad does not xirectpad in the game, although everything in the driver seems to be correct.
If you’re having troubles, and have already double-checked the wiring and diode orientation, try using the Advanced tab in the control panel and increasing the PSX scan delay.
Once connected everything it gives just as it is dual-shock or notwe verified in the configuration of the driver none of the buttons nor any directional ones work. As I said before all the other wires get connected the same way as pad one.
Maybe except to Calibrate the controller. After making sure all the connections are correct you did this first didn’t you?
The optional line is only necessary if you are running a Dual-Shock pad, and want to use force feedback. To hook up the second controller duplicate all connections except DB and DB Instead they would be connected like this:.
Disadvantages You will only be able to direvtpad it in Windows games, since driver it is programmed for DirectX. Now you must do is to install another a second DirectPad driver the same way that you did the first time but this time. The assembly is not very complicated.
| DirectPad Pro | Download
Now cut each one of these wires except the one that does not have insulator that you can cut it directly removing little insulation from the ends of the wires so you have bare wire.
Close everything and executes the direcpad. Take the female connector of the cable and put the pin in each one of the holes to make contact and, using the multi-meter on resistant setting, write down to what hole corresponds each wire of the other end.
Connect the 5v to pin 5 of the pad were the diodes connected and the ground to pins 18 and 19 of the DB connector. Take the 5 diodes and it cuts the ends that are on the side opposition to the mark what marks? Connect it to pin 5 of the pads.
And desire for an adventure itself Make sure that the voltage is 9v using a milti-meter.