GESTETNER DSC38 PRINTER DRIVER DOWNLOAD

Page 29 Installing Options Remove the adhesive tape. Page 40 Setting Up Remove two screws that are fas- tening the Controller Board on the back of the printer using pro- vided screwdriver. Also See for DSc38 Administrator’s manual – 20 pages. Supporting the Duplex Reversal Unit, remove the stopper of the mounting bracket on the printer. Toner dust is flammable and might ignite when exposed to an open flame. Insert four output bins in order, starting from the bottom. Got it, continue to print.

Uploader: Tataxe
Date Added: 8 September 2006
File Size: 17.87 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 54214
Price: Free* [*Free Regsitration Required]

Page 71 Release the lock of the side guide. Install the External Tray to the printer. A Stand it vertically. Page 31 Fasten the bracket with the other thumb screw.

If the Duplex Unit is installed, pro Installing Options Remove the adhesive tape. Page 40 Setting Up Remove two screws that are fas- tening the Controller Board on the back of the printer using pro- vided screwdriver. Page 72 Setting Up After checking that the paper is fixed in place, lock the side guide.

  DESKJET 960C PRINTER DRIVER

Gestetner DSc38 Setup Manual

The side guide and end guide of each paper tray is set to the following values at factory default. Slide the paper tray back slowly until it stops.

To exit Low-power Energy Saver mode, press any key on the operation panel. Page of 82 Go. Align all four sides of the paper stack, and then load it in the tray. Where to Put the Printer The printer’s location should be carefully chosen because environmental condi- tions greatly affect its performance.

For safety, please follow the instructions in this manual. Hestetner the Finisher on the left side of the printer. You can use this to force the printer to If you still cannot step install it properly, contact your sales or service representative.

Fasten the rails with a long screw using pronter screwdriver. B With the 2 Tray Fnisher Tray laid horizontally, slide it in at a slant until it stops. Holding the toner cartridge with the metal contact area in front, at- tach in the direction of the arrow. Page 30 Fasten one thumb screw.

Gestetner Dscu Color | Dsc :: Dsc38 :: 38 – Detailed Printer Specifications

Connecting The Printer Y dsv38 l l o w: B Fold it into printer. A Open the upper left cover. To print the manual completely, please, download it. Connect the power cable to the Controller Board.

  INTEL 82915GM GRAPHICS CONTROLLER 0 XP DRIVER

Toner, developer kits and drums for Gestetner DSC

Page 65 Connect the cable of the 4-bin Mailbox to the lower connector on the back of the printer. It requires a standard pin parallel cable compliant with IEEE and a parallel port available on the host computer. Page 33 Fasten one thumb screw. C Fasten the Prniter Tray with a short screw using provided screwdriver. Remove the ventilator to replace the in- ternal dustproof filter.

Here, you will print the Configura- tion Page to check the options. Rear View Ventilator and Dustproof Filter This ssc38 helps to keep components in- side the printer from overheating.

Insert the rail with a wheel in the mounting bracket.